Console command for Impulse Stop
#6
Thanks for the suggestion of manipulating throttleadjust but the ship stays in FullImpulse.

Apparently FullImpulse and Throttle settings are independent of each other once you are in FullImpulse.

The two are connected when you first hit Shift+R because you go into FullImpulse mode as well as full throttle.

After that, I can set my throttle slider to any value including reverse and stop  (using q, e, and r keys or mouse on the throttle slider GUI).   Regardless of my throttle setting, the FullImpulse is still in effect with the FullImpulse button flashing and all my battery power going to engines.

I am not out of FullImpulse until I hit Shift+R again.

It feels incorrect to be able to be at FullImpulse, but throttle at Zero and ship not moving at all.

So far the only thing I have found that can take you out of FullImpulse is by toggle (Shift+R), mouse pressing the FullImpulse button at the top of the throttle GUI, mouse pressing the Stop button at the bottom of the throttle GUI, or being attacked.
Reply


Messages In This Thread
Console command for Impulse Stop - by BobaTrek - 09-13-2016, 04:00 PM
RE: Console command for Impulse Stop - by Attilio - 09-13-2016, 06:02 PM
RE: Console command for Impulse Stop - by TacPaddy - 09-13-2016, 08:36 PM
RE: Console command for Impulse Stop - by BobaTrek - 09-13-2016, 11:18 PM
RE: Console command for Impulse Stop - by Attilio - 09-17-2016, 01:02 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)
Sponsored Links